840 tile press equipment

Hebei Jinhui tile Machine factory *840* single layer tile machine equipment




 

840 type tile press parameters:
1, reducer :1:29
2, shaft diameter size :1 inch
3, inverter: 7.5KW
4, molding rows :16 rows
5, frame material :350H steel
6. Thickness of the middle plate :16mm
7, chain size :1 inch chain
8. Molding speed :16M/min
9. Motor power :5.5KW
10. Feed thickness :0.4mm-1mm
11. Feed width: 1M
12. Molding width: 840
13. Machine weight :6T
14, equipment size :9500mm*1600mm*1500mm
15, electronic control system: whole machine PLC computer control
16, service life: has been measured more than 2 million meters
Type 840 tile pressing machine is composed of feeding, forming and post-forming cutting. The center line of the lower roll of the tile pressing machine should be on the same plane line, subject to the center wheel, the flatness is not more than 1mm, the gap between the upper and lower rolls in each row is equal, and the gap deviation is +0.1mm. Adjust with a conventional measuring tool or gauge.
840 type tile press equipment is divided into three parts, roller forming part, pressing part, cutting tool part. The forming part of the roller table is driven by the motor, and the chain drives each roll to rotate. The pressing part is the hydraulic cylinder to drive the mold up and down, which can press the color steel into many sections and resemble glazed tiles. The cutting tool part is driven by the hydraulic cylinder to move the tool up and down, which can cut off the colored steel tile.
First of all, the four corners of the front and back lines of the color steel tile pressing machine are the same height from the large frame to the upper end of the shaft, and then from the first row to the last row, find a line to straighten, check whether the lower shaft is in a straight line, and adjust the left and right sides of the lower shaft to the level. Find the center of the first and last row of color steel tile equipment, and then tighten the lock on both sides, pull a straight line before and after the center of the middle wheel, and adjust the gap between the upper and lower axes, you can adjust the machine along the line.

Contact number: 13633176399 (wechat same number)

Contact wechat: 13633176399 (wechat same number)

Contact us at 59458991@qq.com

Website: http://www.13832771638.com

Origin: Hebei, China